Cruise Control Installation

FIGAROS in the USA FORUMS TECHNICAL TOPICS Cruise Control Installation

Viewing 2 reply threads
  • Author
    • #450

      No modern car should be without cruise control, and the Figaro is no exception. I installed a readily-available aftermarket unit in my Figgy, and it looks like it could have come from the factory.

      Full details, photos, and sources can be found here:

    • #509

      Hello Phil, What fuse did you tap in to on the brown wire, or did you splice into a wire?

      I gutted my fig and am in the process of soundproofing. I also removed the carpet so I can give it a deep clean. While I’m there I decided to add the cruise control. I am planning to add the switch to the center console where the ashtray goes. I purchased the surface mount version from Rostra. I am trying to determine how to handle the switch. I want it to be removable in the case I need to remove the center console again. This means I may have to cut the wire(s) going from the switch, and then add a molex on each end, that way the permanent wire can stay in place, and still allow for the removal of the center console. My idea was to make the mod as little destructive as possible. My switch comes with a wire to power a backlight (apparently), so that in of itself brings another challenge of locating a accessible dash wire.

      Carpets not perfect but came out much better than it was!

      You must be logged in to view attached files.
    • #518

      I guess I saw a incomplete guide, I saw the one here and it lists about the brown wire. Now I just gotta figure out where to get “Ignition wire” for the dash switch I purchased. Appears your switch didn’t need it.

Viewing 2 reply threads
  • You must be logged in to reply to this topic.
theme by teslathemes